For this reason its always a good idea to check its condition whenever working on your vehicle. The lower ball joint on this vehicle is a commonly replaced part as takes most of the road wear when traveling over bumpsĪnd surfaces. The upper portion of the suspension is maintainedīy the strut assembly. The Chevy Cobalt has only one set of front control arms being the lower control arms. Reinstall the braking system and then the wheel.Ĭhevy Cobalt Front Axle Nut Torque Spec : 155 ft-lbsĬhevy Cobalt Wheel Hub Bolts Torque Spec : 70 ft-lbs Once both have been torqued you can proceed to Once all are tight you can then put the center axle nut onto the cv axle and torque it down to 155 ft-lbs. The 3 bolts which hold it onto the steering knuckle should be torqued down to 70 ft-lbs. With the new wheel hub installed we can begin to hand tighten down the 3 boltsĪnd then torque them to specs. Once the 3 bolts have been removed you can remove the old part using a hammer and pryīar and then clean the surface and put the new part onto the vehicle. On the back side of the steering knuckle and can be accessed by turning the steering wheel one way and then the other. With those removed we can now gain access to the wheel hub bolts which will be Remove the braking system by taking off the caliper and brake rotor and removing the center axle nut which holds the cv axle to the steering Old part from the vehicle you will need to jack your car up and remove the wheel on the side you are working on. The front wheel hub on the Chevy Cobalt tightens down to the steering knuckle through the use of 3 bolts.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |